Daily Archives: September 21, 2017

21 September 1964

North American Aviation XB70A-1-NA 62-001 takes off for the first time, 21 September 1964. (U.S. Air Force)
North American Aviation XB70A-1-NA 62-0001 takes off for the first time, 21 September 1964. (U.S. Air Force)

21 September 1964: The first prototype North American Aviation XB-70A-1-NA Valkyrie, serial number 62-0001, flown by Chief Test Pilot Alvin S. White and Colonel Joseph F. Cotton, U.S. Air Force, made its first flight from Air Force Plant 42, Palmdale, California, to Edwards Air Force Base.

Originally a prototype Mach 3 strategic bomber, 62-0001 (also known as AV-1) and it’s sister ship, XB-70A-2-NA, 62-0207, (AV-2), were built and used by the Air Force and NASA as high-speed research aircraft. The third Valkyrie, XB-70B-NA 62-0208 (AV-3), was never completed.

Major Joseph F. Cotton, USAF, and Alvin S. White, North American Aviation, with the XB-70A Valkyrie. (Autographed photograph courtesy of Neil Corbett, TEST & RESEARCH PILOTS, FLIGHT TEST ENGINEERS)
Colonel Joseph F. Cotton, USAF, and Alvin S. White, North American Aviation, with an XB-70A Valkyrie. (Autographed photograph courtesy of Neil Corbett, TEST & RESEARCH PILOTS, FLIGHT TEST ENGINEERS)

The B-70 was designed as a high-altitude Mach 3 strategic bomber armed with thermonuclear bombs. The XB-70A is 196 feet, 6 inches (59.893 meters) long with a wingspan of 105 feet (32.004 meters) and an overall height of 30 feet, 8 inches (9.347 meters) . It weighs 231,215 pounds (104,877 kilograms) empty and has a maximum takeoff weight of 534,792 pounds (242,578 kilograms).

The XB-70A was powered by six General Electric YJ93-GE-3 single-spool, axial-flow turbojet engines, which used an 11-stage compressor and two-stage turbine. The engine required a special heat-resistant JP-6 fuel, and was rated at 22,000 pounds of thrust (97.86 kilonewtons), or 31,000 pounds (137.90 kilonewtons) with afterburner. The YJ93-GE-3 was 19 feet, 7.0 inches (5.969 meters) long, 4 feet, 7.0 inches (1.397 meters) in diameter, and weighed 5,200 pounds 2,359 kilograms).

A Boeing B-52 Stratofortress flies formation with North American Aviation XB-70A Valkyrie 62-0001, approaching the runway at Edwards Air Force Base, California. (U.S. Air Force)

The XB-70A had a maximum speed of Mach 3.1 (2,056 miles per hour, or 3,309 kilometers per hour). At 35,000 feet (10,668 meters), it could reach Mach 1.90 (1,254 miles per hour, or 2,018 kilometers per hour), and at its service ceiling of 75,550 feet (23,012 meters), it had a maximum speed of Mach 3.00 (1,982 miles per hour, or 3,190 kilometers per hour). The planned combat range for the production  bomber was 3,419 miles (5,502 kilometers) with a maximum range of 4,290 miles (6,904 kilometers).

North American Aviation XB-70A Valkyrie 62-0001 made 83 flights with a total of 160 hours, 16 minutes flight time. 62-0001 is on display at the National Museum of the United States Air Force, Wright-Patterson Air Force Base, Ohio.

North American Aviation XB-70A Valkyrie 62-0001 lands at Edwards Air Force Base at the end of its first flight, 21 September 1964. (U.S. Air Force)
North American Aviation XB-70A-1-NA Valkyrie 62-0001 just before landing at Runway 4 Right, Edwards Air Force Base, ending of its first flight, 21 September 1964. A Piasecki HH-21B rescue helicopter hovers over the adjacent taxiway. (U.S. Air Force)

© 2017, Bryan R. Swopes

Facebooktwittergoogle_plusredditpinterestlinkedinmailby feather

21 September 1961

Boeing Vertol YCH-1B 59-04984, the number three prototype. (U.S. Army)

21 September 1961: Boeing Vertol YCH-1B, serial number 59-04983, a twin-turboshaft, tandem-rotor helicopter flown by test pilot Leonard La Vasson, made its first flight at Morton Grove, Pennsylvania. This aircraft was the number two prototype of the U.S. Army’s heavy lift transport, the CH-47 Chinook, which is still in production 55 years later.

The YCH-1B fuselage was 51 feet (15.545 meters) long. The counter-rotating three-bladed rotors had a diameter of 59 feet, 1 inch (18.009 meters), each.

The prototypes were powered by two Lycoming LTC4B-3 (T55-L-5) turboshaft engines. These were free-turbine engines using a 7-stage axial-flow, 1-stage centrifugal-flow compressor with a single-stage high-pressure compressor turbine and two-stage low pressure power turbine. The T55-L-5 was rated at 1,870 shaft horsepower at 14,430 r.p.m. N2. It was 3 feet, 8.1 inches (1.120 meters) long and weighed 560 pounds (254 kilograms).

The helicopter had a maximum speed of 186 miles per hour (299 kilometers per hour). It was redesignated YCH-47A in 1962.

The 100th Boeing CH-47F Chinook was delivered to the United States Army in August 2013. (Boeing)
The 100th Boeing CH-47F Chinook was delivered to the United States Army during August 2013. (Boeing)

The Chinook remains in production as the CH-47F, and is used by the military services of several nations.

© 2017, Bryan R. Swopes

Facebooktwittergoogle_plusredditpinterestlinkedinmailby feather

21 September 1942

Boeing XB-29 takes off from Boeing Field, Seattle, Washington. (Boeing)
A Boeing XB-29 takes off from Boeing Field, Seattle, Washington. (Boeing)
Edmund T. ("Eddie") Allen
Edmund T. (“Eddie”) Allen

21 September 1942: At Boeing Field, Seattle, Washington, the Boeing Model 345, the first of three XB-29 prototypes, Air Corps serial number 41-002, took off on its first flight.

Edmund T. “Eddie” Allen, Director of Aerodynamics and Flight Research, was in command, with Al Reed, Chief of Flight Test and Chief Test Pilot, as co-pilot. They climbed to 6,000 feet (1,829 meters) and began testing the XB-29’s stability and control, control power and response, and stall characteristics.

The flight was uneventful. Landing after 1 hour, 15 minutes, Allen is supposed to have said, “She flew!”

The XB-29 was 98 feet, 2 inches (29.921 meters) long with a wing span of 141 feet, 3 inches (43.053 meters), and 27 feet, 9 inches (8.458 meters) high to the top of its vertical fin. The prototype bomber had a gross weight of 105,000 pounds (47,627 kilograms).

Boeing XB-29-BO, 41-002, the first XB-29 built. (U.S. Air Force)
Boeing XB-29-BO, 41-002, the first of three prototypes. (U.S. Air Force)

The prototype bomber was powered by four air-cooled, supercharged and fuel-injected 3,347.662-cubic-inch-displacement (54.858 liter) Wright Aeronautical Division Duplex-Cyclone 670C18H1 (R-3350-13) twin-row 18-cylinder radial engines with a compression ratio of 6.85:1. The R-3350-13 was rated at 2,000 horsepower at 2,400 r.p.m., and 2,200 horsepower at 2,800 r.p.m. for takeoff, burning 100-octane gasoline. These engines drove 17-foot-diameter (5.182 meters) three-bladed Hamilton Standard constant-speed propellers through a gear reduction of 0.35:1. The R-3350-13 was 76.26 inches (1.937 meters) long, 55.78 inches (1.417 meters) in diameter, and weighed 2,668 pounds (1,210 kilograms). Wright built 50 of these engines.

Boeing XB-29 Superfortress 41-18335. This is the third prototype. (Boeing)

The XB-29 had a maximum speed of 368 miles per hour (592 kilometers per hour) and cruised at 255 miles per hour (410 kilometers per hour). Its service ceiling was 32,100 feet (9,784 meters).

The airplane was designed to carry 20,000 pounds (9,072 kilograms) of bombs. Though the prototypes were unarmed, the production B-29s were defended by 10 Browning AN-M2 .50-caliber machine guns in four remotely-operated power turrets, with 2 more .50-caliber machine guns and a single AN-M2 20mm autocannon in the tail.

Boeing B-29A-30-BN Superfortress 42-94106, circa 1945. (U.S. Air Force)
Boeing B-29A-30-BN Superfortress 42-94106, circa 1945. (U.S. Air Force)

The B-29 Superfortress was the most technologically advanced—and complex—aircraft of the War. It required the manufacturing capabilities of the entire nation to produce. Over 1,400,000 engineering man-hours had been required to design the prototypes. It was manufactured by Boeing at Seattle and Renton, Washington, and at Wichita, Kansas; by the Glenn L. Martin Company at Omaha, Nebraska; and by Bell Aircraft Corporation, Marietta, Georgia. There were three XB-29 prototypes, 14 YB-29 pre-production test aircraft, 2,513 B-29, 1,119 B-29A, and 311 B-29B Superfortress aircraft. The bomber served during World War II and the Korean War and continued in active U.S. service until 1960.

The first prototype, 41-002, was scrapped in 1948.

© 2017, Bryan R. Swopes

Facebooktwittergoogle_plusredditpinterestlinkedinmailby feather

21 September 1937

Jackie Cochran sits in the cockpit of the Seversky SEV-S1, NR18Y. Note how the landing gear retracts straight to the rear in this early version. It would be modified to retract inward to the airplane’s centerline, and more effectively streamlined in the future.

21 September 1937: Jackie Cochran flew a Seversky Aircraft Corporation SEV-S1, civil registration NR18Y, over a 3 kilometer course at Detroit Wayne County Airport, Romulus, Michigan, averaging 470.40 kilometers per hour (292.29 miles per hour). This was a new Fédération Aéronautique Internationale (FAI) speed record.¹

The Seversky SEV-S1 Executive was an improved version of the P-35 fighter, which was the first U.S. Army Air Corps single engine airplane to feature all-metal construction, an enclosed cockpit and retractable landing gear. It was designed by Major Alexander P. de Seversky. The airplane had been built as the SEV-2XP, a two-place monoplane with fixed landing gear, powered by an air-cooled, supercharged 1,666.860-cubic-inch-displacement (27.315 liter) Wright Aeronautical Division GR1670 two-row, 14-cylinder radial engine. The GR1670A1 had a compression ratio of 6.75:1 and was rated at 775 horsepower at 2,400 r.p.m., and 830 horsepower at 2,400 r.p.m. for takeoff. The GR1670B2C had a compression ratio of 7.0:1 and was rated at 750 horsepower at 2,500 r.p.m., and 850 horsepower at 2,600 r.p.m., for takeoff. These were developmental engines. Both variants had a propeller gear reduction ratio of 16:11. The SEV-2XP was to be a second entry, along with the SEV-1XP, to enter a fly-off at Wright Field. When it was damaged, though, it was rebuilt as a single place airplane with retractable landing gear and a 1,000-horsepower Wright Cyclone GR-1820G4 nine-cylinder engine, and designated SEV-1XP.

 The Seversky's passenger compartment was accessed through a hatch on the right side of the fuselage. (San Diego Air and Space Museum Archives) Jackie Cochran in the cockpit of the Seversky SEV-2S Executive, NR18Y. Note the passenger windows below and behind the cockpit. (San Diego Air and Space Museum Archives)
The Seversky’s passenger compartment was accessed through a hatch on the right side of the fuselage. (San Diego Air and Space Museum Archives)

After the Air Corps demonstrations, which resulted in an order for 100 P-35s, NX18Y was again repowered, this time with an air-cooled, supercharged, 1,829.39-cubic-inch-displacement (29.978 liter) Pratt & Whitney Twin Wasp S1B3-G (R-1830-11) two-row 14-cylinder radial engine with a compression ratio of 6.7:1. The R-1830-11 was rated at 850 horsepower at 2,450 r.p.m. at 5,000 feet (1,524 meters), and 1,000 horsepower at 2,600 r.p.m. for take off, burning 87-octane gasoline. The engine turned a three-bladed Hamilton-Standard controllable-pitch propeller through a 3:2 gear reduction. The R-1830-11 was 4 feet, 8.66 inches (1.439 meters) long with a diameter of 4 feet, 0.00 inches (1.219 meters), and weighed 1,320 pounds (599 kilograms).

With the R-1830, NR18Y was again redesignated SEV-S1. It was flown by Seversky’s chief test pilot, Frank Sinclair, at the 1937 National Air Races and the Bendix Trophy Race.

Major Alexander P. de Seversky and Jackie Cochran with a Seversky monoplane, circa 1937.
Major Alexander P. de Seversky and Jackie Cochran with a Seversky monoplane, circa 1937.

¹ FAI Record File Number 12026

© 2017, Bryan R. Swopes

Facebooktwittergoogle_plusredditpinterestlinkedinmailby feather