Tag Archives: 46-063

3 May 1948

One of the three Douglas D-558-I Skystreaks. (Smithsonian Institution National Air and Space Museum, NASM A4958D)

3 May 1948: At Muroc Air Force Base in the high desert of southern California (after 1949, known as Edwards AFB), NACA 141, the second of three Douglas D-558-I Skystreak research aircraft, took off on a test flight to study stability at transonic speeds. In the cockpit was National Advisory Committee for Aeronautics Engineering Test Pilot Howard Clifton (“Tick”) Lilly. It was his twentieth flight in the Skystreak.

As Lilly climbed through 200 feet (61 meters), the Skystreak’s J35 turbojet engine suffered a catastrophic compressor failure. Fragments of the compressor cut through the airplane’s flight controls. With Lilly unable to control the airplane, it yawed to the left, then rolled over, and at 3:04 p.m., Pacific Daylight Saving Time (22:04 UTC), crashed onto Rogers Dry Lake. Lilly was decapitated in the crash.

Howard C. Lilly was the first NACA test pilot to be killed during a test flight since the commission had been established in 1915.

NACA Engineering Test Pilot Howard Clifton Lilly.
Howard C. Lilly

Howard Clifton Lilly was born 27 August 1916 at Crow, West Virginia. He was the fourth of five children of Ova Ashton Lilly, a locomotive engineer, and Amanda Elmira Bragg Lilly.

Lilly was given the nickname, “Tickie,” by a friend who, as a child, had been unable to pronounce his middle name, Clifton.

Lilly attended Beaver Elementary School. He graduated from Shady Spring High School, and then attended Beckley College (now, the West Virginia University Institute of Technology), both in Beckley, West Virginia. He also studied at the Concord State Teachers College at Athens, WV (now, Concord University).

Lilly began flying at Mount Hope Airport in Beckley as a member of the Civilian Pilot Training Program. His flight instructor was Karl Williams.

Howard C. Lilly registered for Selective Service (conscription) on 16 October 1940. He was described as having a ruddy complexion with brown hair and blue eyes. Lilly was 5 feet, 10½ inches (179.1 centimeters) tall and weighed 150 pounds (68 kilograms). He was employed as a pressman for the Beckley Newspaper Corporation, and later in the stereotyping department of the Charleston Gazette.

Aviation Cadet Howard C. Lilly, USNR. (Tooley-Myron Studios)

Howard C. Lilly enlisted in the United States Navy as a seaman second class, 11 September 1941, at Washington, D.C. As part of the Navy’s V-5 Program, Seaman Lilly was assigned to U.S. Naval Reserve Aviation Base at Anacostia, D.C., for Elimination Flight Training. He was then transferred to the Naval Reserve Air Base, New Orleans, Louisiana. Although Lilly had hoped to fly fighters, he was assigned to fly seaplanes.

Aviation Cadet Lilly requested to be discharged from the Navy. His request was approved and he was discharged 18 September 1942.

Lilly joined the National Advisory Committee for Aeronautics (NACA) as a test pilot at the Langley Memorial Aeronautical Laboratory, Hampton, Virginia, in October 1942. He was then assigned to the Lewis Flight Propulsion Laboratory, Cleveland, Ohio, in May 1943.

Mrs. H. Clifton Lilly (Raleigh Register)

Howard C. Lilly married Miss Arline Eveyn Grentzer, 20 July 1945, at the St. James Rectory in Cleveland. The ceremony was officiated by Rev. George R. Betting. Following their wedding, the couple resided at the Westlake Hotel in Cleveland. They divorced in 1947.

On 1 September 1946, Lilly flew a Bell P-63A Kingcobra, 42-69063, in the Thompson Trophy Race at Cleveland. His airplane, with civil registration NX69901 and carrying race number 64, had qualified for the race in eighth place with an average speed of 346.155 miles per hour (557.083 kilometers per hour). He finished in ninth place at an average speed of 328.154 miles per hour (528.113 kilometers per hour). Bell Aircraft test pilot Tex Johnston won the race in his Bell P-39Q Airacobra with an average speed of 373.908 mph (601.746 kilometers per hour).

Howard Clifton Lilly, NACA engineering test pilot, with his 1946 Thompson Trophy racer, Bell P-63A NX69901. (NASA E-49-0091)

In August 1947, Lilly was assigned to NACA’s Muroc Flight Test Unit at Muroc Air Force Base as the commission’s first permanently assigned engineering test pilot there. He first flew the Bell XS-1 rocketplane on 9 January 1948. On 31 March 1948, Lilly flew the XS-1 to Mach 1.10, becoming just the third pilot to break sound barrier. Lilly made six test flight in the XS-1, all in the number two aircraft, 46-063.

Bell X-1 46-063. (NASA E49-001)

On 29 April 1948, Lilly flew the D-558-I to 0.88 Mach at 36,000 feet (10,973 meters). This was the highest speed that a Skystreak had reached up to that time.

Howard Clifton Lilly’s remains were interred at the Arlington National Cemetery. Lilly Avenue at Edwards AFB was named in his honor.

In May 1950, Lilly was posthumously awarded the Air Medal.

One the the three Douglas D-558-I Skystreaks in flight near Muroc Air Force Base. (Naval Aviation Museum)

NACA 141 (U.S. Navy Bureau of Aeronautics serial number 37971) was the second of three Douglas D-558-I Skystreak transonic research aircraft.

The D-558 Program was intended as a three-phase test program for the U.S. Navy and the National Advisory Committee on Aeronautics (NACA) to investigate transonic and supersonic flight using straight and swept wing aircraft powered by turbojet and/or rocket engines.

The Douglas Aircraft Company designed and built three D-558-I Skystreaks and three D-558-II Skyrockets. The Phase I aircraft were flown by Douglas test pilot Gene May and the Navy’s project officer, Commander Turner Caldwell.

Cutaway illustration of the Douglas D-558-I Skystreak. (U.S. Navy)

The D-558-I Skystreak was a single-engine, turbojet-powered airplane. It was built of magnesium and aluminum for light weight, but was designed to withstand very high acceleration loads. It was 35 feet, 8 inches (10.871 meters) long with a wingspan of 25 feet (7.62 meters) and overall height of 12 feet, 1¾ inches (3.702 meters). The airplane had retractable tricycle landing gear. Its empty weight was approximately 7,500 pounds (3,400 kilograms), landing weight at the conclusion of a flight test was 7,711 pounds (3,498 kilograms). The maximum takeoff weight was 10,105 pounds (4,583.6 kilograms). The aircraft fuel load was 230 gallons (870.7 liters) of kerosene.

The D-558-I was powered by a single Allison J35-A-11 turbojet engine. The J35 was a single-spool, axial-flow turbojet with an 11-stage compressor section, 8 combustion chambers and single-stage turbine. The J35-A-11 was rated at 5,000 pounds of thrust (22.24 kilonewtons). The engine was 12 feet, 1.0 inches (3.683 meters) long, 3 feet, 4.0 inches (1.016 meters) in diameter and weighed 2,455 pounds (1,114 kilograms). The J35-A-11 was a production version of the General Electric TG-180, initially produced by Chevrolet as the J35-C-3. It was the first widely-used American jet engine.

Cutaway illustration of J35 turbojet engine. (General Electric)

The D-558-I had a designed service ceiling of 45,700 feet (13,930 meters). Intended for experimental flights of short duration, it had a very short range and took off and landed from Rogers Dry Lake at Muroc. The experimental airplane was not as fast as the more widely known Bell X-1 rocketplane, but rendered valuable research time in the high transonic range.

The three D-558-I Skystreaks made a total of 229 flights.

Douglas test pilot Gene May (left) and Howard C. Lilly with the number two Douglas D-558-I Skystreak, Bu. No. 37971, at Muroc, circa 1948. (NASA E95-43116-8)

© 2023, Bryan R. Swopes

6 November 1958

Bell X-1E 46-063 on Rogers Dry Lake. (NASA)
Bell X-1E 46-063 on Rogers Dry Lake, 1955. (NASA)

6 November 1958: NASA Research Test Pilot John B. (Jack) McKay made the final flight of the X-1 rocketplane program, which had begun twelve years earlier.

Bell X-1E 46-063 made its 26th and final flight after being dropped from a Boeing B-29 Superfortress over Edwards Air Force Base on a flight to test a new rocket fuel.

John B. McKay, NACA/NASA Research Test Pilot. (NASA)
John B. McKay, NACA/NASA Research Test Pilot. (NASA)

When the aircraft was inspected after the flight, a crack was found in a structural bulkhead. A decision was made to retire the X-1E and the flight test program was ended.

The X-1E had been modified from the third XS-1, 46-063. It used a thinner wing and had an improved fuel system. The most obvious visible difference is the cockpit, which was changed to provide for an ejection seat. Hundreds of sensors were built into the aircraft’s surfaces to measure air pressure and temperature.

The Bell X-1E was 31 feet (9.449 meters) long, with a wingspan of 22 feet, 10 inches (6.960 meters). The rocketplane’s empty weight was 6,850 pounds (3,107 kilograms) and fully loaded, it weighed 14,750 pounds (6,690 kilograms). The rocketplane was powered by a Reaction Motors XLR11-RM-5 rocket engine which produced 6,000 pounds of thrust (26.689 kilonewtons). The engine burned ethyl alcohol and liquid oxygen. The X-1E carried enough propellants for 4 minutes, 45 seconds burn.

The Bell X-1E rocketplane being loaded into a Boeing B-29 Superfortress mothership for another test flight. (NASA)
The Bell X-1E rocketplane being loaded into NACA 800, a Boeing B-29-96-BW Superfortress mothership, 45-21800, for another test flight. (NASA)

The early aircraft, the XS-1 (later redesignated X-1), which U.S. Air Force test pilot Charles E. (“Chuck”) Yeager flew faster than sound on 14 October 1947, were intended to explore flight in the high subsonic and low supersonic range. There were three X-1 rocketplanes. Yeager’s Glamorous Glennis was 46-062. The X-1D (which was destroyed in an accidental explosion after a single glide flight) and the X-1E were built to investigate the effects of frictional aerodynamic heating in the higher supersonic ranges from Mach 1 to Mach 2.

Bell X-1E loaded aboard Boeing B-29 Superfortress, circa 1955. (NASA)
Bell X-1E 46-063 loaded aboard NACA 800, a Boeing B-29-96-BW Superfortress, 45-21800, circa 1955. (NASA)

The X-1E reached its fastest speed with NASA test pilot Joseph Albert Walker, at Mach 2.24 (1,450 miles per hour/2,334 kilometers per hour), 8 October 1957. Walker also flew it to its peak altitude, 70,046 feet (21,350 meters) on 14 May 1958.

NACA test pilot Joseph Albert Walker made 21 of the X-1E's 26 flights. In this photograph, Joe Walker is wearing a David Clark Co. T-1 capstan-type partial-pressure suit with a K-1 helmet for protection at high altitudes. (NASA)
NACA test pilot Joseph Albert Walker made 21 of the X-1E’s 26 flights. In this photograph, Joe Walker is wearing a David Clark Co. T-1 capstan-type partial-pressure suit with a K-1 helmet for protection at high altitudes. (NASA)

There were a total of 236 flights made by the X-1, X-1A, X-1B, X-1D and X-1E. The X-1 program was sponsored by the National Advisory Committee on Aeronautics, NACA, which became the National Aeronautics and Space Administration, NASA, on 29 June 1958.

The X-1E is on display in front of the NASA administration building at the Dryden Flight Research Center, Edwards Air Force Base, California.Bell X-1E 46-063 on display at Dryden Flight Research Center© 2016, Bryan R. Swopes