Tag Archives: Air Service American Expeditionary Forces

11 April 1918

Colonel William Mitchell with his observer/gunner and their SPAD S.XVI A.2, France, 1918. (U.S. Air Force)
Brigadier General Willam L. Mitchell, United States Army Air Service. (U.S. Air Force)
Brigadier General William Mitchell, Air Service, United States Army. (U.S. Air Force)

The 1st Aero Squadron, I Corps Observation Group, First United States Army, under the command of Colonel William Mitchell, Aviation Section, Signal Corps, United States Army, made its first combat patrol over the front lines from their airfield at Ourches, France. They were equipped with the two-place Société Pour L’Aviation et ses Dérivés SPAD S.XVI A.2. They patrolled the lines, scouted troop movements, and took photographs in support of the U.S. Army I Corps and French XXXVIII Corps. This was the first United States air unit in combat during World War I.

The SPAD S.XVI was intended as an improvement of the earlier SPAD S.XI A.2, which was a two-place development of the SPAD S.XIII C.1 fighter. The S.XVI is single-engine, two-place, two-bay biplane with fixed landing gear. It was crewed by a pilot and observer/gunner. The wings are swept aft approximately 4° and are staggered, moving the center of lift aft to compensate for the airplane’s longer fuselage. The lower wing’s chord is significantly narrower than the upper. Ailerons are on the upper wing only.

The S.XVI A.2 is 7.707 meters (25 feet, 3.425 inches) long with an upper wingspan of 11.220 meters (36 feet, 9.732 inches) and lower span of 10.900 meters (35 feet, 9.133 inches). Its height is 2.850 meters (9 feet, 4.211 inches) with the fuselage in a level attitude. The airplane has an empty weight of 906 kilograms (1,997 pounds) and gross weight of 1,140 kilograms (2,513 pounds).

Société Pour L’Aviation et ses Dérivés (SPAD) S.XVI A.2 at Air Service Production Center No. 2, Romorantin Aerodrome, France, 1918. (U.S. Air Force)
Société Pour L’Aviation et ses Dérivés (SPAD) S.XVI A.2 at Air Service Production Center No. 2, Romorantin Aerodrome, France, 1918. (U.S. Air Force)
Société Pour L’Aviation et ses Dérivés (SPAD) S.XVI A.2 at Air Service Production Center No. 2, Romorantin Aerodrome, France, 1918. (U.S. Air Force)

The SPAD XVI was powered by a right-hand tractor, water-cooled, normally-aspirated, 16.286 litre (993.834 cubic inches) La société industrielle Lorraine-Dietrich 8Be single overhead cam 90° V-8 direct-drive engine which produced 270 cheval-vapeur (270.09 horsepower) at 1,900 r.p.m. The engine weighed 260 kilograms (573 pounds).

Lorraine-Dietrich 8Be V-8 aircraft engine on display at the National Museum of the United States Air Force. (U.S. Air Force)

The SPAD S.XVI was armed with one fixed forward firing, water-cooled, .303-caliber (7.7 mm) Vickers Mk.I machine gun and two air-cooled .303-caliber Lewis Mk.2 light machine guns on a flexible mount in the aft cockpit. Because of the cold temperatures at altitude, the Vickers’ water jacket was not filled, thereby saving considerable weight. The airplane could also carry small bombs attached to the lower wing.

Approximately 1,000 SPAD S.XVIs were built. Six were obtained by the United States. Mitchell’s personal SPAD S.XVI, serial number 9392, is on display at the Smithsonian Institution National Air and Space Museum, Steven F. Udvar-Hazy Center, Chantilly, Virginia.

Colonel William Mitchell's 1st Observation Group SPAD XVI, serial number 9392, at the Smithsonian Institution National Air and Space Museum. (NASM)
Colonel William Mitchell’s SPAD S.XVI A.2 9392 at the Smithsonian Institution National Air and Space Museum. (NASM)

© 2018, Bryan R. Swopes

11 March 1918

1st Lieutenant Paul Frank Baer, Air Service, United States Army. (Campbell Studios, New York)

11 March 1918: 1st Lieutenant Paul Frank Baer, Air Service, United States Army, assigned to the103rd Aero Squadron,  American Expeditionary Forces, flying a SPAD S.VII C-1 chasseur, shot down an enemy Albatros D, near Cerney-les-Reims, France. For this and other actions, Lieutenant Baer was awarded the Distinguished Service Cross.

The President of the United States of America, authorized by Act of Congress, July 9, 1918, takes pleasure in presenting the Distinguished Service Cross to First Lieutenant (Air Service) Paul Frank Baer, United States Army Air Service, for extraordinary heroism in action while serving with 103d Aero Squadron, 3d Pursuit Group, U.S. Army Air Service, A.E.F., on 11 March 1918. First Lieutenant Baer attacked, alone, a group of seven enemy pursuit machines, destroying one, which fell near the French lines northeast of Reims, France. On 16 March 1918, he attacked two enemy two-seaters, one of which fell in flames in approximately the same region.

War Department, General Orders No. 128 (1919)

Lieutenant Baer was the first United States airman to receive the Distinguished Service Cross.

Lieutenant Baer is officially credited by the United States Air Force with 7.75 enemy airplanes shot down between 11 March and 22 May 1918, and he claimed an additional 7. (Credit for two airplanes was shared with four other pilots.) After shooting down his eighth enemy airplane on 22 May 1918, Baer and his SPAD S.XIII C.1 were also shot down. He was seriously injured and was captured by the enemy near Armentières and held as a Prisoner of War. At one point, Baer was able to escape for several days before being recaptured.

For his service in World War I, 1st Lieutenant Paul Frank Baer was awarded the United States’ Distinguished Service Cross with one oak leaf cluster (a second award). He was appointed Chevalier de la Légion d’honneur by Raymond Poincaré, the President of France. He was also awarded the Croix de Guerre with seven palms.

Biplan SPAD de chasse monoplace S.VII (rcgroups.com)

The Société Pour L’Aviation et ses Dérivés SPAD S.VII C.1 was a single-place, single-engine, two-bay biplane chasseur (fighter). The airplane was 19 feet, 11 inches (5.842 meters) long, with a wingspan of 25 feet, 7¾ inches (7.817 meters) and overall height of 7 feet, 2 inches (2.184 meters). It had a maximum gross weight of 1,632 pounds (740 kilograms).

Biplan SPAD de chasse monoplace S.VII (rcgroups.com)

The SPAD VII was initially powered by a water-cooled, normally-aspirated, 11.762 liter (717.769 cubic inches) Société Française Hispano-Suiza 8Aa, a single overhead camshaft (SOHC) 90° V-8 engine with a compression ratio of 4.7:1. The 8Aa produced 150 horsepower at 2,000 r.p.m. By early 1918, the S.VII’s engine was upgraded to the higher-compression 8Ab (5.3:1), rated at 180 horsepower at 2,100 r.p.m. These were right-hand tractor, direct-drive engines which turned a two-bladed fixed-pitch wooden propeller.

The SPAD VII had a maximum speed of 119 miles per hour (192 kilometers per hour). The 8Ab engine increased this to 129 miles per hour (208 kilometers per hour). The service ceiling was 17,500 feet (5,334 meters).

Biplan SPAD de chasse monoplace S.VII (rcgroups.com)

Armament consisted of a single air-cooled Vickers .303-caliber (7.7 × 56 millimeter) machine gun, synchronized to fire forward through the propeller arc.

The SPAD S.VII was produced by nine manufacturers in France and England. The exact number of airplanes built is unknown. Estimates range from 5,600 to 6,500.

The airplane in this photograph is a SPAD S.VII C.1, serial number A.S. 94099, built by Société Pour L’Aviation et ses Dérivés, and restored by the 1st Fighter Wing, Selfridge Air Force Base, Michigan. It is in the collection of the National Museum of the United States Air Force, Wright-Patterson Air Force Base, Ohio.

SPAD VII C.1, serial number A.S. 94099, on display at the National Museum of the United States Air Force. (U.S. Air Force)

© 2023, Bryan R. Swopes

29 April 1918

Lieutenant Edward V. Rickenbacker, 94th Aero Squadron, with a Nieuport 28 C.1 fighter. (U.S. Air Force)

29 April 1918: Lieutenant Edward Vernon Rickenbacker, 94th Aero Squadron, Air Service, American Expeditionary Force, while flying a Nieuport 28 C.1, scored his first aerial victory when he shot down a Deutsche Luftstreitkräfte Pfalz D.III fighter near Saint-Baussant, France. He was awarded the first of eight Distinguished Service Crosses. By the end of World War I, he had destroyed 26 enemy aircraft.

1st Lieutenant Edward V. Rickenbacker in the cockpit of a Nieuport 28 C.1 fighter, France, 1918. (U.S. Air Force)
1st Lieutenant Edward V. Rickenbacker in the cockpit of a Nieuport 28 C.1 fighter, France, 1918. (U.S. Air Force)

The Nieuport 28 C.1 ¹ was a single-place, single-engine, single-bay biplane fighter built by Société Anonyme des Éstablissements Nieuport for the French military. It was rejected, however, in favor of the SPAD S.XIII C.1. The new United States’ Air Service was in great need of fighters. There were none available of American manufacture, and because the new SPAD was in great demand, 297 Nieuport 28s were acquired by the American Expeditionary Force and assigned to the 94th and 95th Aero Squadrons.

U.S. Air Service Nieuport 28 C.1, N6215. (U.S. Air Force)
U.S. Air Service Nieuport 28 C.1, N6215. (U.S. Air Force)

The Nieuport 28 C.1 was 6.30 meters (20 feet, 8 inches) long with an upper wingspan of 8.160 meters (26 feet, 9¼ inches), lower wingspan of 7.79 meters ( 25 feet, 6-2/3 inches)  and height of 2.30 meters (7 feet, 6½ inches). The upper wing had a chord of 1.30 meters (4 feet, 3.2 inches), and the lower, which was staggered behind the upper, had a chord of 1.00 meters (3 feet, 3.4). The upper wing had very slight dihedral, while the lower wing had none. Its empty weight was 399 kilograms (880 pounds) and loaded weight was 626 kilograms (1,380 pounds).

Nieuport 28 C.1, serial number 6215.

The Nieuport 28 C.1 was powered by an air-cooled, normally-aspirated 15.892 liter (969.786-cubic-inch-displacement) Gnome Monosoupape 9 Type N nine-cylinder rotary engine with a compression ratio of 5.45:1. The Monosoupape had a single overhead exhaust valve actuated by a pushrod and rocker arm. As the pistons reached the bottom of their exhaust strokes, a series of intake ports near the bottom of the cylinder were uncovered. The intake charge was drawn from the engine crankcase. The Type N produced 160 horsepower at 1,300 r.p.m. and turned a two-bladed fixed-pitch wooden propeller with a diameter of 2.50 meters (8 feet, 2.4 inches). The engine weighed 330 pounds (150 kilograms).

The Nieuport 28 had a top speed of 198 kilometers per hour (123 miles per hour) at 2,000 meters (6,562 feet) and 1,380 r.p.m., a range of 290 kilometers (180 miles) and a service ceiling of 5,300 meters (17,388 feet). Duration at full power was 1 hour, 45 minutes.

Two .303-caliber Vickers machine guns were mounted on the cowling, firing forward through the propeller arc.

Pfalz D.III (SDASM)

The Pfalz D.III was a single-seat, single-engine, single-bay biplane fighter built by Pfalz Flugzeugwerke. The fuselage was built of two layers of plywood strips laid over a mold to form one half. The two halves were glued together. This was then covered with doped fabric. The wings were made of fabric-covered wood spars and ribs, with wooden ailerons.

It was 6.95 meters (22 feet, 9½ inches) long with a wingspan of 9.4 meters (30 feet, 0 inches) and height of 2.67 meters (8 feet, 9 inches). Empty weight was 695 kilograms (1,532 pounds) and gross weight was 933 kilograms (2,057 pounds).

The fighter was powered by a 14.778 liter (901.812 cubic inches) water-cooled Mercedes D.IIIa single overhead cam inline six-cylinder engine with two valves per cylinder and a compression ratio of 4.64:1. It produced 174 horsepower at 1,400 r.p.m. The D.IIIa weighed 660.0 pounds (299.4 kilograms).

The maximum speed of the Pfalz D.III was 185 kilometers per hour (115 miles per hour) at Sea Level, and the service ceiling was 5,200 meters (17,060 feet).

It was armed with two 7.92 mm LMG 08/15 Spandau machine guns.

Approximately 1,010 Pfalz D.IIIs were built.

Pfalz D.IIIa 8413/17

¹ “C.1” was the French designation for a single-place chasseur, their World War I term for what we now consider to be a fighter.

© 2019, Bryan R. Swopes