Daily Archives: March 28, 2024

28 March 1935

Dr. Robert H. Goddard with one of his liquid-fueled A-series rockets at Roswell, New Mexico, circa 1935. (National Air and Space Museum Archives, Smithsonian Institution, Image Number 84-8949)
Dr. Robert H. Goddard with one of his liquid-fueled A-series rockets at Roswell, New Mexico, circa 1935. (National Air and Space Museum Archives, Smithsonian Institution)

28 March 1935: Near Roswell, New Mexico, Robert H. Goddard successfully launched the first gyroscopically-stabilized liquid-fueled rocket. In a 20-second flight, the A Series rocket, number A-5, reached an altitude of 4,800 feet (1,463 meters) and traveled 13,000 feet (3,962 meters) down range. Its speed was 550 miles per hour (885 kilometers per hour). During the flight, the rocket corrected its flight path several times.

"Dr. Robert H. Goddard observes the launch site from his launch control shack while standing by the firing control panel. From here he can fire, release, or stop testing if firing was unsatisfactory. Firing, releasing, and stop keys are shown on panel. The rocket is situated in the launch tower." (NASA)
“Dr. Robert H. Goddard observes the launch site from his launch control shack while standing by the firing control panel. From here he can fire, release, or stop testing if firing was unsatisfactory. Firing, releasing, and stop keys are shown on panel. The rocket is situated in the launch tower.” (U.S. Air Force)
Goddard A-series rocket. (Clark University)

The A Series rockets were of varying lengths and mass. The representative A-series rocket displayed at the National Air and Space Museum is 15 feet, 4½ inches (468.63 centimeters) long with a diameter of 9 inches (22.86 centimeters). The span across the fins is 1 foot, 9½ inches (54.61 centimeters). It weighs 78.5 pounds (35.6 kilograms). The rocket was fueled with gasoline and liquid oxygen, pressurized with nitrogen.

A gyroscope controlled vanes placed in the engine’s exhaust, providing stabilization during powered flight.

Goddard flew the A-series 14 times between 15 January and 29 October 1935.

The National Air and Space Museum describes the rocket’s construction:

“Aluminum skin, thin gauge, a long tail section from bottom of fins to bottom of mid-section. Aluminum skin also on parachute section and nosecone wholly of spun aluminum except for steel attachment screw. Steel skin (for greater strength and insulation) below nosecone, over mid-section (over propellant tanks), and around small section above fins. One steel tube or pipe on each side of rocket, along propellant section; one smaller diameter copper tube on one side. Steel nozzle and other interior components. Fabric parachute.”

Goddard is the “Father of Modern Rocketry.” Many of his developments were copied by German engineers as they developed the V2 rocket of World War II. And this led to America’s own post-War rocket developments, including the mighty Saturn V moon rocket.

This photograph, taken at the launch site, shows Dr. Goddard with his supporters and his assistants. Left to Right: Albert Kisk, Harry F. Guggenheim, Dr. Goddard, Charles A. Lindbergh, Nils T. Ljungquist and Charles Mansur. (U.S. Air Force)
This photograph, taken at the launch site in New Mexico, shows Dr. Goddard with his supporters and his assistants. Left to Right: Albert Kisk, machinist; Harry F. Guggenheim, philanthropist; Dr.Robert H. Goddard; Charles A. Lindbergh, aviator; Nils T. Ljungquist, machinist; and Charles Mansur, a welder. (U.S. Air Force)
A 1935 A-Series rocket at the National Air and Space Museum, donated by Dr. Robert H. Goddard. (NASM)
A 1935 A-Series rocket at the National Air and Space Museum, donated by Dr. Robert H. Goddard. It is constructed from parts of several A-series rockets which had been test flown. (NASM)
An April 1932 version of Goddard’s gyroscopic stabilization unit. (National Aeronautics and Space Administration GPN-2002-000137)

© 2020, Bryan R. Swopes

28 March 1913

Thomas DeWitt Milling and William C. Sherman, with Burgess Model H biplane, 28 March 1913. (Photograph by Higby Photo)
Lieutenant Thomas DeWitt Milling and Lieutenant William C. Sherman, with the Burgess Model H biplane, 28 March 1913. (Higby Photo)

28 March 1913: Lieutenants Thomas DeWitt Milling and William C. Sherman, Aeronautical Division, Signal Corps, United States Army, set two American Cross-Country Nonstop Records for Distance and Duration by flying a single-engine Burgess Model H Military Tractor (also known as the Burgess-Wright Model H) biplane from Texas City to San Antonio, Texas, a distance of 220 miles (354 kilometers), in 4 hours, 22 minutes.

During the flight Lieutenant Sherman drew a map of the terrain.

Aero and Hydro reported:

American Cross-Country Nonstop Records.—The Aero Club of America, on recommendation of its Contest Commitee, has adopted the following, relative to cross-country flying, nonstop records: Duration—Aviator With Passenger.—Lieutenant T. DeWitt Milling, Texas City, Tex., to San Antonio, Tex., March 28, 1913, Burgess-Wright tractor biplane, 70-horsepower Renault motor; time, four hours, 22 minutes.

Distance—Aviator With Passenger.—Lieut. T. DeWitt Milling, Texas City, Tex., to San Antonio, Tex., Burgess-Wright tractor biplane, 70-horsepower Renault motor; distance covered, 220 miles.

AERO AND HYDRO, Noel & Company, Publishers, Chicago, Illinois, Volume VI, No. 10, 7 June 1913, at Page 190, Column 1

The U.S. Army Signal Corps purchased six Model H biplanes for $7,500, each. They were assigned serial numbers S.C. 9 and S.C. 24–S.C. 28.

The Burgess Model H was a two-place, single-engine biplane which could be ordered with either wheeled landing gear or floats. It was built by the Burgess Company and the Curtiss Aeroplane and Engine Company, under license from Wright.

The biplane was 27 feet, 9 inches (8.458 meters) long with a wingspan of 34 feet, 6 inches (10.516 meters), and weighed 2,300 pounds (1,043 kilograms)

The airplane was powered by a normally-aspirated, air-cooled, 6.949 liter (424.036 cubic inch displacement) Renault Limited left-hand tractor 90° V-8 engine with a compression ratio of 4.12:1. The engine produced 70 horsepower at 1,750 r.p.m., burning 50-octane gasoline. The V-8 drove a two-bladed propeller at one-half of crankshaft speed. (The propeller was driven by the camshaft.) This engine, also known as the Type WB, was manufactured by three British companies: Renault Limited, Rolls-Royce Limited, and Wolseley Motors Limited.

The airplane had a maximum speed of 72 miles per hour (116 kilometers per hour).

Thomas Milling was issued the Fédération Aéronautique Internationale‘s pilot certificate number 30, and the Army’s Military Aviator Certificate No. 1. He was the first U.S. military officer authorized to wear a military aviator badge as part of his uniform.

© 2017, Bryan R. Swopes

28 March 1910

Henri Fabre flying his Hydroavian, 28 March 1910 (Monash University)
A restored image of Henri Fabre flying his Hydroavian, le Canard, at Étang de Berre on the Mediterranean coast of France, 28 March 1910 (CTIE Monash University)

28 March 1910: Henri Marie Léonce Fabre (29 November 1882 – 30 June 1984) flew his Hydroavian, the first seaplane, at Étang de Berre, a lagoon about 25 kilometers (15½ miles) west of Marseille, on the Mediterranean coast of France. The airplane, named Le Canard, flew 457 meters (1,499 feet).

Henri Fabre standing beside the 50-horsepower Gnome engine used to power the Hydroavian. (Fabre Family/AFP via Times of Malta)
Henri Fabre standing beside the 50-horsepower Gnome Omega 7 engine  and propeller used to power the Hydroavian. (Fabre Family/AFP via Times of Malta)

The Hydroavian is 8.45 meters (27 feet, 8.67 inches) long with a wingspan of 14 meters (45 feet, 11.18 inches) and height of 3.70 meters (12 feet, 1.67 inches). It has an empty weight of 380 kilograms (838 pounds) and the gross weight is 475 kilograms (1,047 pounds).

Fabre’s airplane was powered by a normally-aspirated, air-cooled, 7.983 liter (487.140-cubic-inch-displacement) Société des Moteurs Gnome Omega 7-cylinder rotary engine which produced 50 horsepower at 1,200 r.p.m. The direct-drive engine turned a two-bladed wooden propeller in a left-hand, pusher configuration. The Omega 7 is 79.2 centimeters (2 feet, 7.2 inches) long, 83.8 centimeters (2 feet, 9.0 inches) in diameter, and weighs 75.6 kilograms (166.7 pounds). The prototype of this engine is in the collection of the Smithsonian Institution National Air & Space Museum.

Though it was damaged in a crash in 1911, Le Canard was restored and is in the collection of Musée de l’air et de l’espace.

Fabre Hydroavian at Monaco, April 1911 (CTIE Monash University)
Fabre Hydroavian at Monaco, April 1911 (CTIE Monash University)

© 2017, Bryan R. Swopes